In wastewater treatment plants, conductivity probes are installed where the water is dirty by definition. Grease, sludge, scaling and biofilm accumulate on the electrode surface, the reading drifts, and the maintenance team faces a familiar choice: spend hours cleaning a probe that may never return to specification, or replace the whole instrument. The DEC890 conductivity electrode is built to offer a third option, with a measuring head that is replaced rather than repaired.
A conventional sealed conductivity probe treats the electrode as part of the instrument. When the electrode reaches the end of its life, the shaft, the cable, the connector and the communication electronics go with it, even though only a few square centimetres of graphite have actually worn out. In a plant with dozens of measurement points, that replacement pattern dominates the instrument budget and quietly consumes warehouse space with spare complete units.
On the DEC890, the measurement unit is a replaceable structure. The maintenance technician exchanges the measuring module, keeps the stainless steel 316 housing and the 10-meter shielded cable in service, and runs a multi-point calibration to restore full accuracy. The spare-part inventory shrinks to one small module per measuring range instead of a complete sensor per measuring point.
Mounting position is the second reason conductivity readings in wastewater plants underperform. A probe in a dead leg reads stale water, a probe near a pump suction sees air bubbles, and a probe at the top of a horizontal pipe collects gas. The 37mm stainless steel 316 body of the DEC890 is machined with 1-inch NPT threads at both ends, which allows the same sensor to be installed in whichever orientation the process actually permits.
| Side wall installation | Screwed through a tank wall fitting with the measuring end fully immersed and clear of sludge |
|---|---|
| Top flange mounting | Suspended from a flange adapter for open tanks, channels and basins, below the minimum water level |
| Pipeline installation | Fitted in a tee at a low point of the run where flow is steady and bubbles do not accumulate |
| Submerged installation | Front section facing the flow and pushed deep into the moving water body |
| Flow-through installation | Mounted in a bypass chamber so the probe can be isolated and removed without stopping the process |
The sensor is sealed to IP68 and rated for 0~1 Bar working pressure and 0~50°C water temperature. Communication is RS485 MODBUS-RTU at address 17, 9600bps, 8N1 by default, with measured values transmitted as 4-byte floating point data in little-endian byte-swapped order. Because power and communication are isolated, a long bus can be shared with other digital sensors without ground loops, which is how most plant-wide monitoring networks are actually built.
Measurement covers 0~20uS/cm, 20~200uS/cm, 200~2000uS/cm and 2~10mS/cm with 0.01uS/cm, 0.1uS/cm or 1uS/cm resolution and an accuracy of ±1% of the selected range. Graphite electrodes resist fouling better than bare metal surfaces and suppress polarization, so the interval between cleaning operations is longer and the reading is more trustworthy in the period before cleaning.
None of these steps requires opening the housing or returning the instrument to the factory, and a single register command resets the calibration to factory values if a site is reassigned or audited.
For wastewater treatment plants, water stations, surface water programs and industrial effluent monitoring, conductivity measurement is only as good as the maintenance model behind it. A replaceable measuring head, five mounting options and a calibration architecture that can be executed by plant staff turn a fragile measurement into a routine task. The DEC890 is available now from Daruifuno with a choice of measuring ranges, cable lengths and connector types.
Contact the Daruifuno sales team for a quotation, a sample unit or the register map required to integrate the sensor into an existing control system.
Contact Person: Ms. Yuki Fu
Tel: +8615716217387